How to Install LIFX Ceiling Light with Black Trim

By LIFX Smart Lighting | Wi-Fi Bulbs, No Hub Required | Published: 2026-10-17

Category: How-to Guides

Follow this step-by-step guide to install your LIFX SuperColor 26" Ceiling Light with black trim. No hub needed—just Wi-Fi and a few tools.

Quick Answer

Installing the LIFX SuperColor 26" Ceiling Light with black trim is straightforward: mount the bracket, connect wires, snap the fixture in place, and pair via the LIFX app. No hub is required, and the whole process takes about 30 minutes. Just ensure your power is off at the breaker before starting.

What You'll Need

Before you start, gather a few tools: a voltage tester, wire strippers, a screwdriver, and a ladder. The LIFX SuperColor Ceiling Light comes with a mounting bracket, screws, and wire nuts. Make sure your existing junction box is rated for the fixture weight and that you have a 2.4 GHz Wi-Fi network ready for setup.

Safety First

Turn off the power at the circuit breaker for the existing ceiling light. Use a voltage tester to confirm no power is flowing to the wires. This is a critical step—never rely on the wall switch alone. If you're unsure about electrical work, consult a licensed electrician.

Step-by-Step Installation

Remove the Old Fixture: Unscrew and carefully lower your existing light fixture. Disconnect the wires by unscrewing the wire nuts. Set the old fixture aside. Common mistake: Forgetting to note which wire is which. Take a photo before disconnecting to avoid confusion later.
Install the Mounting Bracket: Position the LIFX mounting bracket over the junction box. Use the provided screws to secure it firmly to the ceiling. Ensure the bracket is level. Checkpoint: If your junction box is recessed, you may need longer screws (not included). Test the fit before tightening fully.
Connect the Wiring: Match the wires: connect the black (hot) wire from the ceiling to the black wire on the bracket, white (neutral) to white, and green/bare (ground) to ground. Use the provided wire nuts and wrap each with electrical tape for extra security. Common mistake: Mixing up hot and neutral. Double-check with a voltage tester if unsure. Never leave exposed copper.
Attach the Ceiling Light: Align the fixture's keyhole slots with the bracket's tabs. Push the light upward and twist clockwise until it locks into place. You should hear a click. Checkpoint: If the light doesn't click, it may not be fully seated. Remove, realign, and try again. Forcing it can damage the trim.
Power On and Pair: Restore power at the breaker. Flip the wall switch on. The light should turn on with a default white. Open the LIFX app, tap 'Add Device', and follow the prompts to connect to your Wi-Fi network. Common mistake: The light may not appear if your phone is on a 5 GHz network. Temporarily switch to 2.4 GHz in your router settings, or use the app's Bluetooth fallback if available.

About the LIFX SuperColor Ceiling Light

LIFX SuperColor 26" Ceiling Light Black Trim - 5000 Lumens: A bold, extra-bright ceiling light delivering 5000 lumens of vivid color and brilliant whites. With built-in Wi-Fi, setup is simple and control is instant via voice, app, sensors (not included), or partner integrations. 5000 lumens means this fixture can serve as a primary light source in a living room or bedroom, not just an accent. The built-in Wi-Fi eliminates the need for a separate hub, making installation simpler than many other smart ceiling lights.